Guide / Flashing Information / Boot-Mode Recovery

Simos 18 Boot-Mode Recovery

Boot mode is the last resort for a Simos 18 ECU that normal OBD flashing can no longer reach. It is an advanced bench procedure and may require opening the ECU and working directly at board level.

Contents

When boot mode is needed

A disconnect, interrupted communication or battery voltage that becomes too low does not normally brick a Simos 18 ECU. Fix the cause and restart the flash from the beginning — boot mode is not needed. See Normal interruptions.
An ECU left locked by an incompatible regional cross-flash, where the immobilizer power classes do not match, cannot be recovered over OBD. It must be recovered in boot mode. See The critical cross-flash risk.

Recovery tools

The following open-source project documents the Simos 18 Supplier Bootloader, boot-password recovery and related low-level recovery tools:

Erase addresses

Important: Do not use the Simos 18.1/18.6 erase address on Simos 18.10. Running erase_sector 80800000 on Simos 18.10 erases CBOOT. If CBOOT is erased, recovery is only possible through SBOOT.

Simos 18.1 and Simos 18.6

Use this erase command during boot-mode recovery:
erase_sector 80800000

Simos 18.10

Use this erase command during boot-mode recovery:
erase_sector 80820000

Dumping a Simos 18.10

To dump a Simos 18.10 ECU in boot mode, read these four regions from the bootstrap loader (BSL):
(BSL) compressed_read AF000000 18000 PMU0_DFlash.bin

(BSL) compressed_read AF080000 18000 PMU1_Dflash.bin

(BSL) compressed_read 80000000 200000 PMU0_PFlash.bin

(BSL) compressed_read 80800000 100000 PMU1_PFlash.bin
The PMU1 PFlash read needs a length of 200000 on Simos 18.10, instead of 100000 on Simos 18.1.